Hi I have just baught the G3 A/F ratio gauge and LC-1 from Innovate Motorsports is there any compatability between the Mega jolt and the LC-1 for data loging.
Regards,
Merlin
Mega Jolt compatibality with Logworks
Moderators: JeffC, rdoherty, stieg, brentp
What things would you like to log?
The MJLJ doesn't have any dedicated logging outputs. However, depending on the logging hardware you have, certain things may be possible.
Ignition advance- If the logging system can measure pulse-widths, you extract the ignition advance by having it measure the SAW pulse.
MAP reading- you can probably modify the MJLJ board to bring out the MAP sensor voltage output to an unused pin on the connector; or, if you have TPS you could read the TPS sense line.
RPM - the logger should have this in-built.
Anything I missed?
The MJLJ doesn't have any dedicated logging outputs. However, depending on the logging hardware you have, certain things may be possible.
Ignition advance- If the logging system can measure pulse-widths, you extract the ignition advance by having it measure the SAW pulse.
MAP reading- you can probably modify the MJLJ board to bring out the MAP sensor voltage output to an unused pin on the connector; or, if you have TPS you could read the TPS sense line.
RPM - the logger should have this in-built.
Anything I missed?