Autosport Labs

Would be cool, since this platform is still pretty popular!

However, you should be using the Link direct CAN preset we have in the system, instead of the Lua script - it works much better and has faster response.
https://wiki.autosportlabs.com/CAN_Bus_Integration

Note that this post was from 2017, before we had the direct CAN integration available.

Well I guess we can declare these forums officially dead... That's funny! Our forums don't have a good way of notifying on new posts, like FB and Discord have, and I don't always get to checking for posts. We could do a better job, for sure! The answer to your question is you probably have a channe...

So if I have spark at the plugs then the Crank Position Sensor is not wired backwards, correct? Further, if I have spark at the plugs then the trigger wheel/sensor gap is within an acceptable distance, correct? #1 The crank position sensor is wired correctly. #2 Yes, although if the distance is mar...

Hi, with the Raspberry Pi, you should try to upgrade to the latest firmware; we have a fix where USB data can sometimes have corruption. https://www.autosportlabs.com/racecapture-podiumconnect-firmware-2-19-1/ For iFunBox, are you seeing a case where you can't export data at all (you don't have acce...

Hi, changing colors is on the feature list for a near future release.

A good place to post questions on the Podium app is on Facebook or Discord - we have dedicated sections for it:

https://www.facebook.com/groups/2286217991690195
https://discord.gg/JbKUyFw

THanks!

Hi, please post in one of the other channels here for tuning advice - we don't specifically offer advise for different engine as we may not have experience in that engine; others here with the same engine can provide help. Alternatively, a tuning shop will help you set up your ignition map (it is a ...

Hi, it only works with the EDIS module and the crank trigger wheel, as per the conventional installation.

Hi, it was never enabled on any version.

You have a number of different options sourced from either the EDIS module or the Megajolt unit. Check the Megajolt installation guide on our wiki to see what kind of outputs are possible.

Hi,

Your best bet is to try to perform a factory reset with the firmware and then check it again.

-Brent

Hi, you will be able to see the virtual channel data *after* you record a session that has the virtual channel configured. Example: * Set up a virtual channel; observe it on the dashboard * Perform a logging session (e.g. race some laps) * Session is saved / completed when the logging session is com...

Hi - You can find this information in our specifications: https://wiki.autosportlabs.com/RaceCapt ... ifications

Hi, try post this in our Discord community - there is a special section there for Raspberry Pi support. Invite link: https://discord.gg/JbKUyFw

You could try using a hand signal in front of the camera when it start logging, and then trim the video accordingly. If you're using the RaceCapture/Pro, you can also activate an LED on the dashboard using one of the GPIO outputs.