Search found 95 matches
- Sun Mar 07, 2010 3:54 am
- Forum: New Project Suggestions
- Topic: EDIS Heat Sink
- Replies: 2
- Views: 14593
EDIS Heat Sink
I was wondering if the EDIS components have heat sink requirements. I figured to mount everything except theMJLJ V4 on the engine. Bruce Roe
- Sun Mar 07, 2010 3:20 am
- Forum: New Project Suggestions
- Topic: MAP sensors generally
- Replies: 5
- Views: 19540
I started using a very compact MAP sensor, an 8 pin surface mount chip with a small side port. I picked one that goes a little higher than 1 BAR, puts out about 4 V at 1 BAR. Cost $7.77 in small quantities from MOUSER; MPXAZ6115AP. I believe the technology is the same as automotive units. I use them...
- Sun Mar 07, 2010 3:19 am
- Forum: New Project Suggestions
- Topic: MAP sensors generally
- Replies: 5
- Views: 19540
I started using a very compact MAP sensor, an 8 pin surface mount chip with a small side port. I picked one that goes a little higher than 1 BAR, puts out about 4 V at 1 BAR. Cost $7.77 in small quantities from MOUSER; MPXAZ6115AP. I believe the technology is the same as automotive units. I use them...
- Wed Mar 03, 2010 11:35 pm
- Forum: Q&A
- Topic: ODD FIRE KOHLER
- Replies: 4
- Views: 3952
ODD FIRE KOHLER
Inspiration is an engine, like the front 2 cylinders of small V8. I'm running the 20 hp Kohler ign with EDIS8, 2 coils needed. Since its waste fire, would the other 2 spark output need to be grounded to complete the spark circuit? The engine needs to clear snow at -25 deg F, and cut grass at 100 deg...
- Wed Mar 03, 2010 10:39 pm
- Forum: New Project Suggestions
- Topic: 36-1 Electronic Trigger Wheel Emulation
- Replies: 17
- Views: 174010