RPM signal from MSD 6AL
Posted: Wed Feb 19, 2020 4:27 pm
Hello,
I want to run the RPM output(grey wire) from a MSD 6AL to the FREQ 1 input of the RCP. The output from the 6AL is a 12V square wave clean signal for shift lights/other devices. My question is if I connect the output from 6AL to the FREQ1 input of RCP, is there anything else that needs to be wired?
Thank you
I want to run the RPM output(grey wire) from a MSD 6AL to the FREQ 1 input of the RCP. The output from the 6AL is a 12V square wave clean signal for shift lights/other devices. My question is if I connect the output from 6AL to the FREQ1 input of RCP, is there anything else that needs to be wired?
Thank you