VR sensor selection
Posted: Mon Sep 10, 2018 1:12 am
Folks:
My first post with a simple question.
Putting EDIS 6 on Ford 200 straight six.
Trigger wheel is 36-1 custom made from 1/8" plate steel.
Teeth are .250" square.
What VR sensor do I use?
Part number if you can.
I know the importance of matching tooth width with sensor; so I want to be sure to use the correct one.
My first post with a simple question.
Putting EDIS 6 on Ford 200 straight six.
Trigger wheel is 36-1 custom made from 1/8" plate steel.
Teeth are .250" square.
What VR sensor do I use?
Part number if you can.
I know the importance of matching tooth width with sensor; so I want to be sure to use the correct one.