EDIS Module / Coil Power with Hard Rev Cut

bladerunner80 · Post by **bladerunner80** » Tue Feb 25, 2014 12:45 am

This may be a dumb question, but I'm getting ready to begin wiring on my Mega Jolt setup and I want to make sure I'm reading things correctly. When I purchased my megajolt, I had the hard rev board installed as well. Per the wiring diagram, 12v power to the EDIS module and coil pack are spliced together then ran to a 12 volt source. But, if you have the hard rev board, it shows that this source now comes from a pin on the megajolt.

Do both of these parts get power from the coil power terminal on the megajolt box, or do I wire 12v positive to pin 8 on the EDIS module and 12v positive to the coil via the pin on the megajolt?

bladerunner80 · Post by **bladerunner80** » Wed Feb 26, 2014 5:16 pm

Nevermind, should have done a search before posting this, found several threads with info pertaining to this.

Thanks!