Help with scaling
Posted: Wed Jul 17, 2013 2:11 am
I am trying to scale my coolant guage. I basically used an IR gun aimed next to where the temp probe goes to record temp readings and also use the Sensor Analyzer to monitor voltage readings from the sensor.
Problem is when the readings exceed the upper (or lower) bounds, it just reads 0.00.
Can someone smarter to me figure out roughly (I don't care if its dead nuts on) what voltage readings would be 260*, 310*, and 30* given the following values:
2.62v, 85*
2.55v, 120*
2.47v, 130*
2.40v, 150*
2.30v, 170*
2.20v, 185*
2.06v, 195*
1.90v, 215*
1.83v, 220*
Thanks.
-Scott
Problem is when the readings exceed the upper (or lower) bounds, it just reads 0.00.
Can someone smarter to me figure out roughly (I don't care if its dead nuts on) what voltage readings would be 260*, 310*, and 30* given the following values:
2.62v, 85*
2.55v, 120*
2.47v, 130*
2.40v, 150*
2.30v, 170*
2.20v, 185*
2.06v, 195*
1.90v, 215*
1.83v, 220*
Thanks.
-Scott