V3 board coming soon!

[brentp]

See the front page for details!

[brentp]

I'm now accepting pre-orders for Version 3.0. See the Order page for more information.

New vor V3.0: Completed units can be ordered pre-configured with MAP sensor or TPS.

Brent

[S Wolf]

I can't find the BOM, Schematic or board drawing for the v3.0. It appears that the v3.0 has less parts then the v2.2. Can someone point me to them?

Steve

[brentp]

I'm just about ready to ship. Should start this week.

I've written up most of the build instructions, I will be working on the BOM next...

Thanks,
Brent

[Vorpal]

I thought that the DigiKey BOM that currently comes on the order page was for v3.0 (since you don't have any more v2.2 boards). Are most of the components the same, at least? Or did I totally waste my money?

-Winston

1986 Toyota MR2 getting a 20v 4AGE "Silvertop" swap

[Ivan]

Is it possible to work with the two sensors together and create
a 3D mapping system?
If I am correct we have a 2D system now.
I have been doeing some testing with the car and there is improvement.
Now that the carbs are jetted proper the car can go for its first race
next week (Hillclimb Bomerée in Belgium).
I see that on the v3.0 board the transistors are replaced with a chip,
won't this be more difficult to replace?

Ivan

[Vorpal]

Brent,

Just wondering if you could answer my question above, and also checking on the status of the v3.0 boards.


1986 Toyota MR2 getting a Silvertop 4AGE 20v swap

[brentp]

Yes! I have the 3.0 digikey parts order page up.

I'm going to continue re-organizing the website to put V2 and V3 in their respective categories.

The page is under "Information Library"
http://picasso.org/mjlj/?q=node/508

Brent

[Vorpal]

Thanks, Brent. Glad to see that most of the parts interchange.

Any ETA on the boards?

-Winston

1986 Toyota MR2 getting a Silvertop 4AGE 20v swap

[Vorpal]

Got my board and my digi-key order... all parts have arrived!


1986 Toyota MR2 getting a Silvertop 4AGE 20v swap