I have fitted a eaton m 90 with lpg on my rover V8 ( no gasoline)
Now i am looking for a ignition map, at first it started after a lot of starting and revd verry hard, found that there was a vacuum leak. Fixxed it and did not run since then
Now even with megajolt disconnected, it will not even start up, a bitt of backfire, not running annymore.
I have tried the standard map on the cd rom, and with vacuum advance disconnected, no luck.
Should i take vacuum advance from the suction off the blower ore use the pressure side ?
I have sett the megajolt to pressure and with the needle saying 100 kpa this is atmopsheric pressure ? So iff the needle go's tot lets say 30 this is more vacuum ?
Superchargerd Rover V8
Browse and share Ignition Configurations in this forum
Moderators: JeffC, rdoherty, stieg, brentp
Return to “Ignition Map Library”
Jump to
- Autosport Labs
- ↳ General Discussion
- ↳ News and Announcements
- ↳ New Project Suggestions
- CAN Devices
- ↳ ShiftX2
- ↳ AnalogX
- RaceCapture App
- ↳ RaceCapture App Operation and General Q&A
- ↳ RaceCapture App Bug Reporting / Feature Requests
- CAN bus and OBDII integration
- ↳ CAN mapping discussion
- ↳ OBDII PIDs discussion
- RaceCapture/Pro | RaceCapture/Apex | PodiumConnect
- ↳ RaceCapture/Pro introductions
- ↳ RaceCapture/Pro General Q&A
- ↳ Sensors
- ↳ Hardware and Installation
- ↳ Lua Scripting
- ↳ Telemetry
- ↳ Bug Reporting
- ↳ Feature Requests
- RaceCapture/Track
- ↳ RaceCapture/Track Introductions
- ↳ RaceCapture/Track Operation
- ↳ RaceCapture/Track Installation
- ↳ RaceCapture/Track Bug Reporting / Feature Requests
- Megajolt/E and Megajolt Lite Jr. (MJLJ)
- ↳ Ignition Map Library
- ↳ Powered by Megajolt Gallery
- ↳ Assembly
- ↳ Installation
- ↳ Operation
- ↳ Q&A
- ↳ Future Upgrades
- ↳ Bug Reporting
- ↳ Fixes/Patches/Updates
- ↳ Hard Rev Limiter