Gidday,
A newby from the Antipodies who is on a very steep learning curve.
Fitting the Wabash TPS as supplied with the MJ.
The hole ID on the TPS is 8mm, the OD on the Weber shaft is 6.5mm.
Is there a spacer available or do I make one.?
Thanks,
Les.
TPS fitting
Moderators: JeffC, rdoherty, stieg, brentp
Hello Les,
Here is how I solved it, but you may find ready-made ones (Weber).
Cheers.
Jos
Here is how I solved it, but you may find ready-made ones (Weber).
Cheers.
Jos
- Attachments
-
- Adapter (selfmade)
- axis_profile.JPG (28.59 KiB) Viewed 5672 times
-
- trial fit
- TPSadaptor.JPG (19.2 KiB) Viewed 5672 times
Last edited by luxseven on Fri May 13, 2011 7:59 am, edited 1 time in total.
If all else fails, consult the manual.
My blog: http://jacob-jos.blogspot.com/
My blog: http://jacob-jos.blogspot.com/
-
- Posts: 4
- Joined: Sun May 08, 2011 9:32 pm
- Location: QLD, Australia
TPS.
Gidday Luxseven,
Thanks for the reply, food for thought.
Travelled through your beautiful country when completing in a Classic car rally in 1999.
Les.
Thanks for the reply, food for thought.
Travelled through your beautiful country when completing in a Classic car rally in 1999.
Les.