Search found 7 matches
- Mon Jan 12, 2015 7:31 am
- Forum: Installation
- Topic: VRef and TPS Sensor Question
- Replies: 2
- Views: 4292
- Fri Jan 09, 2015 6:12 am
- Forum: Installation
- Topic: VRef and TPS Sensor Question
- Replies: 2
- Views: 4292
VRef and TPS Sensor Question
Can I use the VRef and Negative pins on the megajolt box to power my TPS sensor for my air/fuel meter? I'm installing a TPS sensor on one of my carbs to use with my Innovate LM-2 and I read the VRef pin on the MJ box provides a 5v power lead which the TPS sensor needs. I'm assuming the TPS sensor dr...
- Wed Jul 09, 2014 10:25 pm
- Forum: Installation
- Topic: Connecting LM-2 Wideband to Megajolt E
- Replies: 3
- Views: 6041
Connecting LM-2 Wideband to Megajolt E
I was looking to connect my LM-2 Wideband O2 monitor to my megajolt e. I read a few topics on here that explain how to do this and also provide configuration files to get it set up. There is a note on the instructions that I have to "cut R6" on the megajolt board. I have a couple questions...
- Wed Feb 26, 2014 5:16 pm
- Forum: Installation
- Topic: EDIS Module / Coil Power with Hard Rev Cut
- Replies: 1
- Views: 3239
- Tue Feb 25, 2014 12:50 am
- Forum: Installation
- Topic: Multiple Tach Signal outputs
- Replies: 2
- Views: 4778
Thanks for the reply. I just assumed it would be easier to wire the tach via the optional tach output board, from reading, it seems there are a lot of people who have trouble getting a proper signal via the EDIS/Megajolt, but maybe I'm understanding it correctly. I'll take your suggestion and do it ...
- Tue Feb 25, 2014 12:45 am
- Forum: Installation
- Topic: EDIS Module / Coil Power with Hard Rev Cut
- Replies: 1
- Views: 3239
EDIS Module / Coil Power with Hard Rev Cut
This may be a dumb question, but I'm getting ready to begin wiring on my Mega Jolt setup and I want to make sure I'm reading things correctly. When I purchased my megajolt, I had the hard rev board installed as well. Per the wiring diagram, 12v power to the EDIS module and coil pack are spliced toge...
- Fri Jan 31, 2014 10:29 pm
- Forum: Installation
- Topic: Multiple Tach Signal outputs
- Replies: 2
- Views: 4778
Multiple Tach Signal outputs
I'm getting ready to install the megajolt system in my bug and I'm adding a Innovate Motorsports LM-2 Air/Fuel Ratio gauge/data logger to the mix as well. I purchased the tach adapter from Autosport labs, will it be ok to connect both my data logger and my VDO tachometer to the signal output from th...