Autosport Labs

Found a lot of bad wiring in the car.12v Ign was falling off while cranking and the engine had bad ground.I got spark but still no start.What is the spark plug wire routing to the coil?

What gap do you have between the sensor and trigger wheel? When you say 'waveform is good' what peak-to-peak voltage are you reading while monitoring it? I over lapped the waveform on the one supplied for my modis that the car is suppose to have.I dont remember the V.Ill redo and tell ya..... Provi...

brentp wrote:Got it, thank you for clarifying.

If you pull a plug do you see any spark during cranking?

Do you have consistent +12V to the EDIS module and coil pack *while* the engine is cranking?

No spark @ coil or spark plug.12v yes.

It's all covered in the diagram in the installation guide. When you say ICM what do you mean exactly? Are you using a Ford EDIS module (EDIS-4, EDIS-6 or EDIS-8) ? Icm( Ignition control module) yes edis-4.Ive been threw the diagrams.Everything is hooked up the same as explained in the diagrams.That...

What all is needed to make this edis work without the mj? Coil,icm,ckp sensor, and the wheel?

Hello, So what problems are you experiencing, exactly? And, where are you at in the installation process? The engine should be runnable on EDIS alone (without the megajolt connected) at the default 10 degrees BTDC. After the EDIS module is running the engine, the Megajolt can be hooked in to contro...

Hello and welcome. The information you seek is in our wiki (how-to section linked at top) http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide http://www.autosportlabs.net/MJLJ_V4_Operation_Guide This should get you going! Thank you! No help here..Double checked everything,I even slapped...

First off the mj and edis is all used.Im pretty sure the ign module is bad but..... I hook everything up as in the installation pics.Using the minimal required diagram.I have power and ground where I needed it.The ckp sensor is hooked up right.I tried it both ways to make sure.I scoped the ckp senso...

brentp wrote:Hello and welcome.

The information you seek is in our wiki (how-to section linked at top)

http://www.autosportlabs.net/MJLJ_V4_ve ... tion_guide
http://www.autosportlabs.net/MJLJ_V4_Operation_Guide

This should get you going!

Thank you!

I have a customer that brought me a mj2 and edis 4.I am guessing its used from what I can tell?I know how the setup is suppose to work.I understand the pins for the edis4.I do not know what the pins on the 16 pin connector are? Where could I get those diagrams?Or do I just open it up and look at the...