Autosport Labs

It was the supply for the afm as i didnt need it anymore dont know why the power was going when i was turning her over?

Right it was a silly thing! wasnt going to say but it might help someone else if they get the same problem here we go. I was trying it again tonight holding the spark pulg to an earth and turnig it over still no spark, But then i noicted a slight small spark just as i stopped turning the engine over...

Yeh they are but there is 12v at the coil pack on all 3 pins is that right?

This is how i have wired it

Yeh im using the right pin numbers heres my eidis 4



Pin one is the right handside one in the picture is that right?
I checked my vr sensor this morning and it is giving out 2.8-3.4v is that ok?
Thanks

I just read that the shelid for the vr sensor should not be earthed directly but i have could this be my problem?

Hi i tryed wiring in my megajolt today but i have no spark. I connected the sensor withe screened cable and grounded the screen with the ground of the edids 4 i connected to the coilpack as the installation guide says and i tryed swapping the wires on the vr sensor still nothing. What i found strang...

Yeh sure

Will the c20xe dispack work with megajolt the same as the ford one or would i be better with the for one? Thanks

Yeh sorry that was it Have put a new map on it already the base map for the xe on carbs of this site. That was easy when connected right! Thanks for all the help

Thanks but what do you mean the same as the configuration software were can i check what it is set to and whats it on? Thanks

I cant get my laptop to see the megajolt i am connected to it through a serial cable and have it powered up with a 9v battery i have set the port settings to Baud rate 4800 Data bits 8 Parity n stop bits 1 flow control none but when i open the configurator v3.2.1 It doesnt load anything and if i cli...

Does the missing tooth not have to be 90 degrees from top dead center but?

Have been trying to figure out were can i mount my vr sensor? CAn i mount it anywere round were i have turn the line round the outside? Thanks

Hi i have looked at the install guide but my wires are a different colour and i cant figure out which pin is num 1 on the units so i have uploaded pictures if someone could tell me which wire connects to which all im doing is running carbs i dont need a rev limit or anything just a spark If anyone c...