Autosport Labs

Thanks guys, After spending some time on installing and going through the usual problems, wiring, trigger wheels etc, we moved onto mapping, we had two test cars Toms and Adams 1380, http://i14.photobucket.com/albums/a336/MLMOTORSPORT/ROLLING1-1.jpg Adams car a 1380cc phase 3 cam, stage 3 head, twin...

its V3, its a pain as I had the output working making it simple, Ill have to got the diode route I suppose.....

Hi guys, After various problems mainly me, I got my system working ok, once I had the engine running I tested the output of the tach output pin on the edis as there was no wire in the plug, using a piece of welding wire I sucessfully had the original tacho working (90s mini) I couldnt make a permane...

Ah I think I still have the trigger wheel incorrect then as its currently set with the engine at tdc and the missing tooth looking at the sensor so I need to move it again.

Ok reset trigger wheel with engine at TDC and gap next to sensor, swapped round the tdc sensor wires and now have a spark at both sides of the coil but engine fluffs and bangs, using the strobe at the pulley shows trigger wheel gap at TDC so where am I going wrong! Ive run through the wiring again a...

ehh I think I found the problem,

My trigger wheel is notched at tdc! will be checking it later.

Ok gone back through my wiring as the sparks have stopped! I found I had incorrectly wired the coil plug had only one side of the coil working, I have rewired it and now have nothing! I have a spare edis module and coil pack and have tried these to no avail I have checked for power supply to each it...

thanks for that will check it out, there does not seem to be a spark now so plan to check the wiring as i used the diagrams supplied on the disc with the kit and reading on here they are not correct? engine runs fine on the old dizzie so no problems there as another aside its a 1mm airgap on the tdc...

Hu guys,

Just installed a jolt lite jnr on a mini and am curently trying to get it to run on edis only, Im getting a spark but the engine wont run, before I remove the wiring to check it is there any obvious items to check?

coil leads are 1 to 1 etc

many thanks,