Autosport Labs

Hi brentp, Would it be possible to some way use the switch input to control the hard drive rev limiter what I need is a way to hold the revs on a limiter wile a switch is pressed on the steering wheel and as soon as the switch is in the off state ( ie a push to make or push to brake type switch) the...

Thanks Bernt that has solved the problam for me your a legend really really appresiate that one best regards,Paul. Happy christmas to one and all as well. :

how did you get on with this brent any look sorting it,
best regards,
Paul

No one any ideas

Hello all well have my V4 up and running very happy with it. right I have the single wire trimester hooked up to the MJ and it reads although the voltage dose seem a bit low its reading 0,0V at 75deg and something in the region of 5V at cold need to check these again to be sure. It is the standard t...

Hello Guys something just struck me when I set a figure of we'll say for istance 20 deg of advance on a particular bin is that 20 crankshaft deg or 20 Distributor deg?, The reasion I am asking is I was just looking at my last map and found that Im runing 16 deg at idel which is exactly twice what th...

High all, I have the mega jolt fitted to my 1380 A series engine in a Mini I conected the standard Mini rev guage up to one of the ford coil pack Earth, No the problam when I am ideling it reads the croect rev well the same as the computer a when I rev the engine it also reads the same except some t...

High Bernt, Just a quick one you where saying the other day that you might be devloping a way to get a temp sensor input with current Mjlj would it be possable for this to trigger one of the outputs ie switch a relay at a certen temp. Any help as always very much appreciated, Kind regards, Paul.

Hi this is a bit of topic but the map showen abouve is In some program called IAW are you using this program to design and control you Mega Jolt and is it any different to Bernts software
Regards,
Paul.

Hi all I have been trying to acess thes sight over the last cupple of weeks and can't get to to respond does anyone have a copy of ipaqsparker or tell me how to get hold of a copy.
Any help would be great guys,
Paul.

brent, Just read this tred now this might be just the solve for a problam I am having at the moment is there anyway I might be able to rig this to work. I have kinda got around the problam which is high Co2 at idel by opening the plug gap up to 1.05mm to hold the spark for longer but multi spark wou...

Thanks brent,

that is spot on RPM and MAP is realy all I want I think that LogWorks trough the LC-1 uses voltage as it trighers so not sure how to get RPM in trought this

wha mods do you recon i would need to make to the board to get a map voltage out.

Thanks for all your help.

Hi I have just baught the G3 A/F ratio gauge and LC-1 from Innovate Motorsports is there any compatability between the Mega jolt and the LC-1 for data loging.
Regards,
Merlin

Hi Brent,
I havent got a chance to mesure the coil resistance yet but as soon as I do I will get back to you.

Ok done a Little work on this and I have come up with a little compremise(spelling). I e-Bayed 4 Renault Pencil coils and conected them to a spare EDIS modul in two banks IE coil one and four where conected to out put A and coil two and three to out put B with a positive feed to all four and an neg ...